Recep Tayyip Erdoğan Üniversitesi Kurumsal Akademik Arşivi
DSpace@RTEÜ, Recep Tayyip Erdoğan Üniversitesi tarafından doğrudan ve dolaylı olarak yayınlanan; kitap, makale, tez, bildiri, rapor, araştırma verisi gibi tüm akademik kaynakları uluslararası standartlarda dijital ortamda depolar, Üniversitenin akademik performansını izlemeye aracılık eder, kaynakları uzun süreli saklar ve yayınların etkisini artırmak için telif haklarına uygun olarak Açık Erişime sunar.

Güncel Gönderiler
High-efficiency direct in-band pumping of Tm:LuAG with a 1 W single-emitter diode
(Optica Publishing Group (formerly OSA), 2026) Bilici, Hatice; Kaya, Fatma; Demirbas, Umit; Beyatlı, Ersen
We demonstrate a compact and efficient Tm:LuAG laser operating at 2023 nm, directly in-band pumped at 1621 nm by a high-brightness 1 W single-emitter diode. Five crystals with 4% and 6% Tm3+ doping and lengths of 3–7 mm were compared in the same X-fold resonator. In continuous-wave (CW) operation, the 4%, 7 mm crystal produced 147 mW at 10°C with a local absorbed-pump slope efficiency reaching 76.6%. Comparison of the five crystals showed that the benefit of increased pump absorption with crystal length was eventually offset by reabsorption and passive loss, particularly at the higher Tm3+ concentration. The optimum crystal also maintained good spatial beam quality, with average M2 values of 1.58 and 1.03 along the horizontal and vertical axes, respectively. The same platform provided 138 nm of continuous tuning from 1937 to 2075 nm, stable two- and three-line emission, and SESAM-based passive Q-switching, with pulse durations down to 2 μs, peak powers up to 564 mW, and pulse energies up to 1.42 μJ. To our knowledge, the measured absorbed-pump slope efficiency is the highest reported for a directly diode-pumped CW Tm:LuAG laser.
The impact of fiber types on the mechanical and microstructural properties of one-part alkali-activated mortars after sequential freeze-thaw and elevated temperatures exposure
(Elsevier, 2026) Yılmaz, Yılmaz; Nas, Memduh; Kuleyin, Hamdi; Nayır, Safa; Baki, Vahiddin Alperen
One-part alkali-activated mortars (OPAAMs) have attracted increasing attention as alternative binders because of their environmental benefits and favorable mechanical performance. However, information regarding the performance of these materials is limited, particularly in situations where environmental effects occur sequentially. In particular, the effect of prior freeze–thaw (F–T) damage on the subsequent high-temperature resistance of these materials has not been sufficiently elucidated. Therefore, the primary objective of this study is to determine how pre-existing F–T damage affects the subsequent high-temperature performance of OPAAMs and to evaluate the effectiveness of different fiber types and fiber contents in mitigating this sequential damage. To this end, glass (G), basalt (B), polypropylene (PP) and carbon (C) fibers were added to the mixtures at volume fractions of 0.5% and 1.0%. After being subjected to 125 F–T cycles, the specimens were heated to temperatures of 400 °C and 800 °C, and their mechanical, phase and microstructural properties were evaluated. The results showed that F–T pre-damage had a clear effect on the subsequent response to elevated temperatures, and this effect depended on fiber type. Fiber addition generally improved strength and toughness by reducing brittle behavior, particularly in flexure. The highest mechanical performance was obtained with C fibers. Increasing the fiber content from 0.5% to 1.0% further improved strength and energy absorption, especially in C- and B-fiber mixtures. In contrast, PP-fiber mixtures showed lower compressive and flexural strengths due to increased porosity. All mixtures deteriorated after 400 °C, with greater losses at 800 °C. However, mixtures with 1.0% C fiber retained the highest residual compressive and flexural strengths. Mass loss was limited after F–T but increased significantly at elevated temperatures due to water loss, dehydroxylation, and decarbonation. XRD and FTIR results indicated gel decomposition and reduced polymerization with increasing temperature. FESEM–EDS showed complete decomposition of PP fibers, while G and B fibers remained relatively stable. C fibers provided the most effective reinforcement due to their high thermal stability. The results show that F–T pre-damage plays an important role in the subsequent thermal performance of fiber-reinforced OPAAMs.
Green synthesis of multifunctional ag/zno nanoparticles using vitis labrusca l. Extract: bioactivity, malachite green adsorption, and hmf removal
(Springer, 2026) Hammoudeh, Rama; Bozbeyoğlu, Pınar; Karpuz, Ömer; Gül, Abdulkadir; Ejder, Nebahat; Baltacı, Cemalettin
In this study, Ag/ZnO nanoparticles (Ag/ZnO NPs) were synthesized via a green route using Vitis labrusca L. extract and evaluated for their bioactive, environmental performance. BM-1 and BM-2 were prepared under different precursor/extract ratios and pH conditions to assess the influence of synthesis parameters. UV–Vis, FT-IR, XRD, HRTEM, DSC, and EDX analyses indicated the successful formation of Ag/ZnO nanostructures with distinct physicochemical features. HRTEM analysis determined that BM-1 exhibited an average particle diameter of 23.18 ± 11.84 nm, while BM-2 demonstrated a mean size of 6.14 ± 1.30 nm. The corresponding relative size-dispersion values were 0.261 for BM-1 and 0.045 for BM-2, indicating a more uniform particle size distribution for BM-2. Antioxidant assays showed that BM-2 exhibited the strongest overall antioxidant performance in DPPH, ABTS•⁺, Fe3+, and Cu2+ assays. Both NPs exhibited antibacterial activity against Gram-positive and Gram-negative bacteria and showed stronger effects than the grape extract alone. Cytotoxicity assays revealed dose-dependent inhibition in A549 and HeLa cancer cells, while lower toxicity was observed in normal ARPE-19 cells, suggesting cell-type-dependent biological response. In adsorption experiments, the NPs effectively removed malachite green, with isotherm analysis providing stronger support for the Langmuir model for BM-1 and comparable Langmuir and Freundlich fits for BM-2, while the pseudo-second-order model provided the best description of the adsorption kinetics. The maximum dye adsorption capacities were 85.5 mg/g for BM-1 and 101.3 mg/g for BM-2. Under optimum conditions (5.0 g/L NPs, 240 min), the highest HMF removal efficiencies reached 44.49% for BM-2 in standard aqueous solutions, whereas competitive matrix interactions in apple juice limited the maximum efficiency to 29.27%. Overall, this study highlights the value of integrating green synthesis, bioactivity, dye adsorption, and food-related contaminant removal within a single Ag/ZnO nanoplatform.
Design, synthesis, and anticancer evaluation of novel chalcone derivatives bearing piperazine and morpholine moieties
(Wiley, 2026) Çalışkan, Nedime; Yılmaz, Fatih; Eyüpoğlu, Ozan Emre; Emirik, Mustafa; Menteşe, Emre
Cancer remains one of the leading causes of mortality worldwide, highlighting the need for novel anticancer agents with improved efficacy and selectivity. In this study, a series of chalcone derivatives bearing phenylpiperazine, 2-fluorophenylpiperazine, and morpholine moieties (1a–g, 2a–g, and 3a–g) were designed, synthesized, and evaluated for their anticancer potential. The target compounds were synthesized via Claisen–Schmidt condensation under basic conditions and characterized by 1H NMR, 13C NMR, and elemental analysis. Their cytotoxic activities were assessed against PC-3, PANC-1, A549, and MCF-7 cancer cell lines using the MTT assay, with HEK-293 cells serving as a non-cancerous control. Most compounds exhibited notable antiproliferative activity and favorable selectivity compared with doxorubicin, cisplatin, and gemcitabine. Among the tested cell lines, A549 cells were the most sensitive. Compounds 2d, 2b, 2c, 2e, 2g, and 2a showed particularly potent activity against A549 cells, with IC50 values of 5.35 ± 0.08, 5.71 ± 0.09, 5.95 ± 0.09, 5.83 ± 0.09, 5.94 ± 0.09, and 5.96 ± 0.09 µM, respectively. Notably, 2c exhibited the highest selectivity toward A549 cells (SI = 3.26). SAR analysis indicated that the 2-fluorophenylpiperazine moiety enhanced anticancer activity, while halogen substitution generally improved potency and selectivity. Induced Fit Docking and Glide XP simulations supported these findings, suggesting that 2d and 2c achieve their activity through key hinge-region anchoring and isoform-specific interactions with PI3K-α and PI3K-γ. Overall, these findings identify fluorinated chalcone derivatives, particularly 2d, as promising leads for further anticancer drug development.
A hybrid snake and grey wolf optimizer for load frequency control in photovoltaic thermal power system
(Springer, 2026) Özkul, Eda; Tezel, Özge; Can, Özay
Metaheuristic algorithms are widely employed to solve complex and high-dimensional real-world optimization problems. However, standalone algorithms often suffer from drawbacks such as premature convergence, stagnation in local optima, insufficient exploration of the search space, and unstable solution quality. To address these limitations, this study proposes a novel hybrid optimization algorithm, called SOGWO, by combining the leadership-guided search mechanism of the grey wolf optimizer (GWO) with the strategic update mechanisms of the snake optimizer (SO). The proposed hybrid structure aims to enhance exploration capability, maintain population diversity, and improve the balance between exploration and exploitation. Firstly, SOGWO is tested on 23 classical benchmark, 12 CEC-2022 test functions and compared with 13 well-known and recent algorithms to demonstrate its superiority. The experimental results demonstrate that SOGWO successfully combines the advantages of both constituent algorithms and consistently produces high-quality solutions. Statistical analyses indicate that SOGWO ranks second for the 10-dimensional problems and achieves the best overall performance for the 20-dimensional problems. To further assess its practical applicability, SOGWO is employed to optimize proportional–integral (PI) controller parameters for the load frequency control (LFC) problem in a two-area photovoltaic–thermal power system. The obtained results confirm the effectiveness of the proposed algorithm in solving a real-world engineering optimization problem and improving control performance. Moreover, the proposed SOGWO incurs a significant computational cost due to its population-based structure and applicability to large-scale problems, indicating that SOGWO has the potential to be suitable for high-performance computing (HPC), parallel, and distributed architectures. Consequently, the proposed algorithm can be suggested as a reliable and effective method for the solution of HPC and real-life engineering applications.



















