Ara
Toplam kayıt 74, listelenen: 61-70
Performance assessment of oxygenated CdS films-based photodetector
(Elsevier, 2024)
dS films were grown by thermal evaporation on glass substrates. After growth process, samples were oxygenated at 400 °C at various gas pressures for 5 mins employing rapid thermal process. The produced CdS films were used ...
Improving solar cell efficiency through controlled annealing effects of TiO2 thin films
(Wiley, 2024)
In the scope of this research, the impact of thermal annealing on the electrical and optical characteristics of TiO2 thin films is investigated through empirical analysis. Varied annealing temperatures are applied during ...
An investigation on CdSeTe/CdTe stacks deposited by evaporation: Impact of Halide treatment depending on the applied surface
(Wiley, 2024)
Among the methods applied to modify the characteristics of CdSeTe/CdTe stacks, one of the most well-known and widely used procedures is the CdCl2 halide treatment. In this connection, the influence of CdCl2 on microstructural ...
Preparation and characterization of new window material CdS thin films at low substrate temperature (<300 K) with vacuum deposition
(Elsevier, 2011)
Low-temperature vacuum deposition instead of the commonly used vacuum deposition at high substrate temperatures has been applied to prepare new window material CdS thin films. The structural, optical and electrical properties ...
Effect of CdCl2/annealing on the crystalline transformation of CdTe thin films grown by evaporation at a low substrate temperature
(TÜBİTAK, 2011)
The structural and optical properties of CdTe thin films prepared at a low substrate temperature were investigated before and after the CdCl 2/annealing. The crystal structure of CdTe film was cubic with a strong (111) ...
Current transport mechanism in CdS thin films prepared by vacuum evaporation method at substrate temperatures below room temperature
(Elsevier, 2012)
CdS thin films were deposited by vacuum deposition method at low substrate temperatures instead of the commonly used vacuum deposition at high substrate temperatures (T S > 300 K). The effect of low substrate temperature ...
Structural and optical properties of ZnO and Al-doped ZnO microrods obtained by spray pyrolysis method using different solvents
(Elsevier, 2012)
ZnO and Al-doped ZnO microrods were obtained by spray pyrolysis method using different solvents such as methanol and propanol. The effect of the type of solvent in the starting solution on the structural, morphological and ...
Growth and characterization of CT(S,Se) thin films and Al/n-Si/p-CT(S,Se)/Mo heterojunction diode application employing a two-stage process
(Elsevier, 2023)
Cu2SnS3 (CTS), Cu2Sn(S,Se)3 (CTSSe), and Cu2SnSe3 (CTSe) thin films were deposited on n-type silicon wafer substrates using a two-stage process. This process involved drop-coating Cu-Sn precursors, which is different from ...
Semi-conductive carbon from industrial tea waste biomass for a p-n junction
(Springer, 2024)
Some semiconducting carbonaceous material was developed from industrial tea waste biomass by catalytic pyrolysis and heteroatom doping; then, a p-n junction was realized on an n-type Si substrate. I-V characteristics of ...
Erratum to: Synthesis and fabrication of Mg-doped ZnO-based dye-sensitized solar cells(J Mater Sci: Mater Electron, (2014), 25, 3173-3178, DOI 10.1007/s10854-014-2000-5)
(Springer, 2014)
Abstract Undoped and 2, 4 and 6 at.% Mg-doped ZnO
nanorods were successfully deposited on ZnO seeded
fluorine tin oxide substrates by a simple chemical bath
deposition technique to form a photoanode. It was seen that
all ...