| dc.contributor.author | Aktarer, Semih Mahmut | |
| dc.contributor.author | Sekban, D.M. | |
| dc.contributor.author | Yanar, H. | |
| dc.contributor.author | Purcek, G. | |
| dc.date.accessioned | 2020-12-19T20:17:25Z | |
| dc.date.available | 2020-12-19T20:17:25Z | |
| dc.date.issued | 2017 | |
| dc.identifier.citation | Aktarer, S.M., Sekban, D.M., Yanar, H. & Purcek, G. (2017). Effect of friction stir processing on tribological properties of Al-Si alloys. IOP Conference Series: Materials Science and Engineering, 174(1), 012061. https://doi.org/10.1088/1757-899X/174/1/012061 | en_US |
| dc.identifier.issn | 1757-8981 | |
| dc.identifier.uri | https://doi.org/10.1088/1757-899X/174/1/012061 | |
| dc.identifier.uri | https://hdl.handle.net/11436/4385 | |
| dc.description | et al.;Nanomechanics, Inc.;S.C. Total Lubricants Romania S.A.;SC Etansari Grafex SRL;SC NASDIS Consulting SRL;SC Techno Volt SRL | en_US |
| dc.description | 13th International Conference on Tribology, ROTRIB 2016 -- 22 September 2016 through 24 September 2016 -- -- 126834 | en_US |
| dc.description.abstract | As-cast Al-12Si alloy was processed by single-pass friction stir processing (FSP), and its effect on mainly friction and wear properties of processed alloy was studied in detail. The needle-shaped eutectic silicon particles were fragmented by intense plastic deformation and dynamic recrystallization during FSP. The fragmented and homogenously distributed Si particles throughout the improve the mechanical properties and wear behavior of Al-12Si alloy. The wear mechanisms for this improvement were examined and the possible reasons were discussed. © Published under licence by IOP Publishing Ltd. | en_US |
| dc.language.iso | eng | en_US |
| dc.publisher | Institute of Physics Publishing | en_US |
| dc.rights | info:eu-repo/semantics/openAccess | en_US |
| dc.title | Effect of friction stir processing on tribological properties of Al-Si alloys | en_US |
| dc.type | conferenceObject | en_US |
| dc.contributor.department | RTEÜ, Teknik Bilimler Meslek Yüksekokulu, Motorlu Araçlar ve Ulaştırma Teknolojileri Bölümü | en_US |
| dc.contributor.institutionauthor | Aktarer, Semih Mahmut | |
| dc.identifier.doi | 10.1088/1757-899X/174/1/012061 | |
| dc.identifier.volume | 174 | en_US |
| dc.identifier.issue | 1 | en_US |
| dc.relation.journal | IOP Conference Series: Materials Science and Engineering | en_US |
| dc.relation.publicationcategory | Konferans Öğesi - Uluslararası - Kurum Öğretim Elemanı | en_US |
