Başlık için Mühendislik Fakültesi listeleme
Toplam kayıt 847, listelenen: 186-205
-
Early Cambrian S-type granites in the Sakarya Zone, NE Turkey: A record for transition from subduction to post-collisional extension deduced from U-Pb zircon age and Nd-Hf isotopes
(Elsevier, 2022)Cadomian realms have recently received much attention in the Alpine-Mediterranean orogenic belts, with discontinuous outcrops extending from the Alps to the Istanbul Zone, Menderes Massif, Taurides in Turkey and Iran as ... -
Early Cambrian S-type granites in the Sakarya Zone, NE Turkey: A record for transition from subduction to post-collisional extension deduced from U[sbnd]Pb zircon age and Nd[sbnd]Hf isotopes
(Elsevier, 2022)Cadomian realms have recently received much attention in the Alpine–Mediterranean orogenic belts, with discontinuous outcrops extending from the Alps to the İstanbul Zone, Menderes Massif, Taurides in Turkey and Iran as ... -
Editorial for special issue on frontiers and advances in cemented paste backfill
(Springer, 2023)... -
Editorial: Advances in the design and implementation of cementitious backfills
(Frontiers Media, 2022)Backfill plays an essential role in the most modern mining industries worldwide. It is usually applied in the cementitious form to fill underground mined-out openings (stopes and/or voids) -
Efects of Covid‑19 outbreak on environment and renewable energy sector
(Springer, 2020)Many articles have been written in the medical feld related to the Covid-19 outbreak that has surrounded the World and killed many people. However, its environmental and energy impacts have not been sufciently studied. ... -
Effect of 3D printed skeleton shapes on strength behavior, stress evolution and microstructural response of cement-based tailings backfills
(Elsevier, 2024)The inherent brittle behavior of cement-based tail backfill (CTB) poses some challenges that can significantly impact the safety and effectiveness of underground mining operations. Due to its propensity for abrupt and ... -
Effect of a new type staggered pin fin configuration on flow boiling characteristics of micro-heat sinks
(Springer, 2023)Flow boiling in micro-pin fn structured heat sinks is an up-to-date thermal management technique. However, due to microsized fow passages, bubble blockage is a problem for this type of heat sinks, too. In addition, mixing ... -
The effect of ABS fraction on the fatigue behavior of PMMA/ABS polymer blends
(Elsevier, 2022)This paper aims to examine the fatigue behavior of the Poly(methyl methacrylate)/ Acrylonitrile-butadiene-styrene (PMMA/ABS) polymer blends by means of experimental studies. For the material characterization of the blends, ... -
Effect of air change rate on particle dispersion from inlet opening under varying particle source strengths
(Taylor and Francis Ltd., 2020)In this study, effect of air change rate (air change per hour–ACH) on indoor particle dispersion and deposition in a ventilated room is investigated. A reduced-scale model is designed to conduct experiments. Numerical ... -
Effect of air exhaust location on surgical site particle distribution in an operating room
(Tsinghua Univ Press, 2020)This study investigates effect of exhaust outlet location on airflow and particle distribution in an operating room with laminar ventilation system (LAF) via computational fluid dynamics (CFD). Four different exhaust opening ... -
Effect of air pressure on nanofiber production in solution blowing method
(Gazi Univ, Fac Engineering Architecture, 2020)In this study, effect of air pressure on nanofiber diameter and morphology was studied for solution blowing technique. A computational fluid dynamics (CFD) analysis was realized via ANSYS (R) Fluent software, and the results ... -
Effect of aluminosilicate precursors and curing regime on physico-mechanical durability and microstructural characteristics of coral geopolymers (Cor-Geo): Cleaner production for coral islands
(Elsevier, 2023)This study investigated the mechanical, durability, microstructure, carbon footprint and cost characteristics of new-generation metakaolin-based geopolymer composites. Instead of GBFS, 25 % metakaolin was used, and 25 ... -
Effect of annealing temperature on K-shell X-ray fluorescence parameters of zinc oxide thin films prepared by the sol-gel method
(Taylor & Francis Inc, 2019)Zinc oxide thin films were grown on a glass substrate by a sol-gel process using a spin-coating technique. the obtained thin films were annealed between 350 degrees C and 550 degrees C in 50 degrees C steps and were then ... -
Effect of arc re-melting on microstructure, mechanical and tribological properties of commercial 390A alloy
(Elsevier, 2021)To investigate the effect of the arc re-melting on the microstructure, mechanical and tribological properties of the 390A alloy, its ingot produced by the conventional induction melting method was subjected to the arc ... -
Effect of boronizing on operating stability of steel AISI 304L under erosion impact of hard particles
(Springer, 2021)The effect of solid boronizing at 950 degrees C for 2 and 4 h on the phase composition, microstructure, hardness and abrasive wear of steel AISI 304L is studied under the impact of a flow of hard particles. The boronized ... -
The effect of capillarity on chloride transport and the prediction of the accumulation region of chloride in concretes with reinforcement corrosion
(Elsevier, 2012)In this study, 20-year-old residential buildings which have reinforcement bar corrosion in their basement columns were investigated in Rize, Turkey. The reason for the occurrence of high steel corrosion in only some certain ... -
Effect of case depths on corrosion properties of hard anodic oxidized A356 aluminum alloy
(World Stientific Publishing, 2023)In this work, A356 alloy samples having a dimension of 4x20x20mm were coated by hard anodic oxidation method at eight different thicknesses up to similar to 80 mu m. The sample surfaces and longitudinal section of these ... -
Effect of characteristics of natural zeolites on their geopolymerization
(Elsevier, 2021)The properties of clinoptilolite-based geopolymers are investigated with a focus on the parameters affecting the reactivity of clinoptilolite in a geopolymer binder. A complete characterization of raw materials was carried ... -
Effect of content and length of polypropylene fibers on strength and microstructure of cementitious tailings-waste rock fill
(MDPI, 2023)The mechanical strength properties of cemented tailings backfill are very important for the safe and environmentally friendly mining of mineral resources. To check the impact of polypropylene fiber on strength and ...
