Başlık için Mühendislik Fakültesi listeleme
Toplam kayıt 847, listelenen: 439-458
-
Influence of downstream cross-sectional area ratio on flow boiling characteristics of expanding micro pin fin heat sinks
(Elsevier, 2023)In the present study, influence of downstream cross-sectional area ratio on flow boiling behavior of expanding micro-pin-fin heat sinks was experimentally studied. Three structured micro-pin-fin heat sinks, namely, Type1, ... -
The influence of exhaust gas recirculation on the characteristics of compression ignition engines powered by tamanu methyl ester
(Oxford University Press, 2022)This study aims to assess the performance of compression ignition (CI) engine powered with various biodiesels. The engine used for this test was a single-cylinder, water-cooled, naturally aspirated, CI engine. The biodiesels ... -
Influence of film thickness and composition on the martensitic transformation in epitaxial Ni-Mn-Sn thin films
(Pergamon-Elsevier Science Ltd, 2015)Two series of epitaxial Ni-Mn-Sn thin films of different thickness are investigated for the thickness and composition dependence of the martensitic transformation. Thin films ranging in thickness from 20 to 200 nm (series ... -
Influence of Ge content and annealing conditions on the PL properties of nc-Si1-xGex embedded in SiO2 matrix in weak quantum confined regime
(Elsevier Science Bv, 2014)Fabrication of Si (nc-Si), Ge (nc-Ge), and Si1-xGex (nc-Si1-xGex) nanocrystals embedded in SiO2 matrix is achieved by thermal annealing of magnetron-sputtered thin films. Effects of annealing conditions, namely duration ... -
Influence of hydrofluoric acid leaching and roasting on mineralogical phase transformation of pyrite in sulfidic mine tailings
(Mdpi, 2020)Under the oxidative roasting process, pyrite, as a major mineral in sulfidic mine tailings, can transform to iron oxides. Generated iron oxides, if exhibiting enough magnetic properties, can be recovered via magnetic ... -
Influence of industrial solid waste as filling material on mechanical and microstructural characteristics of cementitious backfills
(Elsevier, 2021)Use of industrial solid wastes (e.g., fly ash, desulfurization gypsum, steel slag) as mine fill material not only solves the environmental risks dictated by the sustainable management of these wastes, but also reduces the ... -
Influence of solid content, cement/tailings ratio, and curing time on rheology and strength of cemented tailings backfill
(Mdpi, 2020)Understanding the flow process of cemented tailings backfill (CTB) is important for successful pumping into underground stopes. This study examines the effects of solid content (SC), cement/tailings (c/t) ratio, and curing ... -
Influence of types and contents of nano cellulose materials as reinforcement on stability performance of cementitious tailings backfill
(Elsevier, 2022)This study explores the quality of cemented tailings backfill (CTB) reinforced with diverse nano cellulose materials (NCMs) such as micro-fibrillated cellulose (MFC), hydroxylated cellulose nanofiber (CNF), and cellulose ... -
Influence of types and shapes of 3D printed polymeric lattice on ductility performance of cementitious backfill composites
(Elsevier, 2021)The compression properties of cementitious backfill composite (CBC) is strong, but their tension properties are weak and presents little ductility because of their low fatigue crack growth rate and resistance. Thus, proper ... -
Influence of ventilation strategies on dispersion and removal of fine particles: An experimental and simulation study
(Taylor & Francis Inc, 2020)In this study, effect of inlet/outlet configurations on the dispersion and removal of fine particles are examined experimentally and numerically. Ten different inlet/outlet configurations are tested for three different ... -
The influence of Y contribution on crystallographic, topographic and optical properties of ZnO: A heterojunction diode application
(Academic Press Ltd- Elsevier Science Ltd, 2015)Pure and yttrium (Y) doped ZnO samples were fabricated on micro slide glasses and p-Si wafers for device application via a simple and cheap sol-gel route using a spin coater. the characterization results of XRD, SEM and ... -
Innovative mine backfill materials and structures
(Taylor & Francis Ltd., 2023)The mining of natural resources forms three broad classes of mine waste: waste rock, tailings, and coal gangue. -
Integration of smart grid with renewable energy sources: Opportunities and challenges – A comprehensive review
(Elsevier, 2023)Renewable energy is the most promising solution to the rising problem of greenhouse gas emissions, and it also contributes to environmental protection. A typical electrical grid is a unidirectional system that converts ... -
Interleukins: Pathogenesis in non-alcoholic fatty liver disease
(MDPI, 2024)Inflammatory cytokines have been implicated as crucial contributors to the onset and progression of non-alcoholic fatty liver disease (NAFLD). The exact mechanisms by which interleukins (ILs) contribute to NAFLD may vary, ... -
Introducing the chemical potential of Cu-Mn-Al alloys for structural, electrical and thermal properties
(Springer, 2024)This study investigates the Martensite transition in Cu-Mn-Al alloys (CMAs) via the use of many methods, including scanning electron microscopy, temperature-dependent X-ray diffraction, resistivity and thermal measurements. ... -
Inverse magnetocaloric effect of epitaxial Ni-Mn-Sn thin films
(Amer Inst Physics, 2013)Epitaxial Ni-Mn-Sn thin films of 200 nm thickness were prepared by magnetron sputtering and deposited onto MgO(100) substrate. They reveal an inverse magnetocaloric effect with a martensitic phase transition around 260 K. ... -
Inverse magnetocaloric effect related to the magnetostructural phase transition in quaternary Ni-Co-Mn-Al alloy
(Springer, 2021)The inverse magnetocaloric effect of Ni-Co-Mn-Al quaternary alloy with the relatively low material cost is achieved firstly in a theoretical study (V. Sokolovskiy et al.: J. Appl. Phys., 2020, vol. 127, p. 163901). To ... -
Investigating formability behavior of friction stir-welded high-strength shipbuilding steel using experimental, finite element, and artificial neural network methods
(Springer, 2024)Steels are preferred in the building of commercial ships because they can be easily welded and supplied. Although it varies according to the parts of the ships, it is known that high-strength steels are preferred especially ... -
Investigating the exergetic and environmental effects of subcooling and superheating processes on the performance of direct expansion systems
(Springer International Publishing, 2014)Recently, subcooling and superheating applications, which are proposed as an approach for the efficient use of energy, have positive effect on the emission next to increasing the energy efficiency. This study examines ... -
Investigating the informative brain region in multiclass electroencephalography and near infrared spectroscopy based BCI system using band power based features
(Taylor & Francis Ltd., 2024)In recent years, various brain imaging techniques have been used as input signals for brain-computer interface (BCI) systems. Electroencephalography (EEG) and near-infrared spectroscopy (NIRS) are two prominent techniques ...
