Başlık için Mühendislik Fakültesi listeleme
Toplam kayıt 847, listelenen: 463-482
-
Investigation of a hybrid solar and geothermal driven absorption cooling system for district applications
(Inderscience Enterprises Ltd, 2012)In this paper, a new hybrid geothermal and solar driven absorption cooling system (ACS) is proposed for low-temperature district energy applications. Two approaches are proposed in this study, namely: (a) a new model for ... -
Investigation of beaches suitable for nourishment in Rize Province, Turkey
(Middle East Technical University, 2009)Black Sea Coast Motorway was recently built along the shore (about 600 km), and a number of beaches were destroyed. Now there are a couple of short beaches in Eastern Black Sea region. People need new beaches. On the other ... -
Investigation of biogas and hydrogen production from waste water of milk-processing industry in Turkey
(Elsevier, 2012)This study is conducted to determine the potential for producing both biogas and hydrogen from a milk-processing waste water in Turkey. The results of this study indicate that a maximum of 54.2 million m 3 biogas/yr and ... -
Investigation of Cd1-xCoxS diluted magnetic semiconductor thin films fabricated by chemical bath deposition method
(Elsevier Science Sa, 2014)Chemical bath deposition method was used for preparation of Cd1-xCoxS thin films. the effects of Co doping and thermal annealing on structural, optical, electrical and magnetic properties of CdS thin films were investigated. ... -
Investigation of clean energy production in drinking water networks
(Springer, 2024)Viable renewable energy sources must be low-cost, easy to install, clean, and reliable if they are to meet the energy demand of urban or rural areas. Water is able to provide efficient sources of electrical energy among ... -
Investigation of continuous and discontinuous contact cases in the contact mechanics of graded materials using analytical method and FEM
(Techno-Press, 2021)The aim of this paper was to examine the continuous and discontinuous contact problems between the functionally graded (FG) layer pressed with a uniformly distributed load and homogeneous half plane using an analytical ... -
Investigation of flat plate type pulsating heat pipes via flow visualization-assisted experiments: Effect of cross sectional ratio
(Elsevier, 2021)In the present study, combined influence of filling ratio, geometry, inclination angle and heating power on heat transfer characteristics of the pulsating heat pipes (PHPs) are investigated accompanying analysis of complex ... -
Investigation of GSM, LTE and Wi-Fi electromagnetic radiation in dwellings
(Polish Acad Sciences Inst Physics, 2017)Electromagnetic radiation exposure increases with the rise of the wireless communication devices. Electromagnetic radiation, especially near 2400 MHz band, has gradually increased with the widespread of wireless fidelity ... -
Investigation of heat transfer limits for flow boiling in expanding heat sinks having micro pin fins
(Elsevier, 2024)Critical heat flux (CHF) represents heat transfer limit for a heat sink working under flow boiling conditions. In the literature, for the first time, in micro-pin-fin heat sinks with expanding structure, this paper ... -
Investigation of micro-tube solid oxide fuel cell fabrication using extrusion method
(Pergamon-Elsevier Science Ltd, 2016)Extrusion is one of the most effective and inexpensive methods used in the production of ceramic tubes for tubular or micro-tubular solid oxide fuel cell (SOFC) applications. in this method, the parameters such as the ... -
Investigation of nano ulexite mineral effects on mechanical behaviour of warm mix asphalt pavements
(Croatian Soc Civil Engineers-Hsgi, 2020)The research presented in the paper shows that further investigations on additives used in the warm mix asphalt technology are needed. It was observed that the negative effect of adhesion loss in asphalt mixes produced by ... -
Investigation of passive radar target detection performance improvement by using multiple co-located FM radio transmitters
(2019)Interest in passive radar systems is increasing because of its hidden operational capabilities, cost effectiveness and low maintenance requirements. The greatest advantage of these systems is that they can detect and follow ... -
Investigation of photocatalytic performance of GaN-WSSe under vertical strain
(Recep Tayyip Erdoğan University, 2023)The utilization of mechanical strain is an essential way to modify and optimize the physical properties of materials, possibly making them usable for a variety of applications, including nanoelectronics and renewable ... -
Investigation of photoluminescence mechanisms from SiO2/Si:SiO2/SiO2 structures in weak quantum confined regime by deconvolution of photoluminescence spectra
(Amer Scientific Publishers, 2016)Si nanocrystals embedded in SiO2 matrix were prepared by co-sputtering method followed by a post annealing process in N-2 ambient. By fixing sputtering parameters, the effects of annealing time and annealing temperature ... -
The investigation of stability of n-CdS/p-Cu2S solar cells prepared by cold substrate method
(IOP Publishing, 2021)In this study, two different n-CdS/p-Cu2S solar cells were prepared by evaporating Cu at different substrate temperatures (200 K and 300 K) by vacuum evaporation method on a single crystal CdS semiconductor. Field emission ... -
Investigation of temperature distribution and performance of SOFC short stack with/without machined gas channels
(Pergamon-Elsevier Science Ltd, 2016)Solid oxide fuel cells (SOFCs) generate clean energy via electrochemical reactions at high operating temperatures. the distribution of the electrochemical reactions in the cell depends on the flow field design of the ... -
Investigation of the cutting forces and surface roughness in milling carbon fiber reinforced polymer composite material
(Inst Za Kovinske Materiale I in Tehnologie, 2016)In this study, milling of a carbon-fiber-reinforced polymer composite material (CFRP) was investigated experimentally using various carbide end mills. the input parameters included the spindle speed, feed rate and cutting ... -
Investigation of the effect of different power degree NdFeB magnets used in interior permanent magnet brushless direct current motor (IPMBLDC) on motor performance
(Gazi Üniversitesi, 2023)Purpose: In this study, it is aimed to determine the effects of magnets used in BLDC motors on the motor performance of NdFeB type magnets with different power densities at different temperatures. Theory and Methods: The ... -
Investigation of the effects of miscible and immiscible binary fluids on thermal performance of pulsating heat pipes
(Springer, 2021)Present paper reports and discusses experimental results related to thermal and flow characteristics of asymmetrical designed flat plate closed loop pulsating heat pipe charged with miscible and immiscible binary fluids. ... -
Investigation of the effects of T5 and T6 heat treatments on the structural, mechanical, and tribological properties of Zn-40Al-2Cu-0.1Sr alloy
(Gazi Üniversitesi, 2024)To assess the effects of T5 and T6 heat treatments on the structural, mechanical, and tribological properties of Zn-40Al-2Cu-0.1Sr alloy several ingots were produced by the permanent mold casting. The structure and properties ...
