Ara
Toplam kayıt 198, listelenen: 91-100
Room temperature superplaticity in fine/ultrafine grained materials subjected to severe plastic deformation
(Japan Inst Metals & Materials, 2019)
Achieving superplasticity at high temperatures and at very low strain rates is considered to be the most important disadvange of superplastic forming processes. Therefore, it is crucial to achieve superplastic behavior at ...
On the tse of nanofluids in solar energy applications
(Springer, 2020)
Renewable energy technologies are in the centre of interest to narrow the gap between fossil fuels and clean energy systems. the dominant role of solar energy systems among the alternatives is beyond question owing to being ...
Particle dispersion and deposition in displacement ventilation systems combined with floor heating
(Taylor & Francis Inc, 2020)
The aim of this study is to investigate dispersion and deposition characteristics of different particle diameters (0.5-5-10 mu m) for a displacement ventilated and floor heated environment, experimentally and numerically. ...
Enhanced performance figures of solar cookers through latent heat storage and low-cost booster reflectors
(Oxford Univ Press, 2020)
Solar box cookers draw attention of many researchers across the globe as a promising renewable energy application for cooking purposes. Compared to other types available in literature, solar box cookers are more in the ...
Determination of delamination in drilling of carbon fiber reinforced carbon matrix composites/Al 6013-T651 stacks
(Elsevier Sci Ltd, 2020)
Delamination at the hole entrance and exit during drilling of the FRPs composites adversely affects the hole surface quality and engineering properties of this material. in this study, delamination occurrence in hole ...
Machinability properties of Al-7Si, Al-7Si-4Zn and Al-7Si-4Zn-3Cu alloys
(Springer Heidelberg, 2020)
Al-7Si, Al-7Si-4Zn, Al-7Si-4Zn-3Cu alloys were produced by permanent mold casting method to investigate the effects of copper and zinc additions on the machinability properties of Al-7Si alloy. the structural and mechanical ...
Effect of zinc content and cutting tool coating on the machinability of the Al-(5-35) Zn alloys
(Korean Inst Metals Materials, 2020)
In this study, Al-5Zn, Al-15Zn, Al-25Zn and Al-35Zn alloys containing 5, 15, 25 and 35 wt% Zn, respectively were produced by permanent mold casting. Their microstructures and mechanical properties were investigated using ...
Effects of titanium addition on structural, mechanical, tribological, and corrosion properties of Al-25Zn-3Cu and Al-25Zn-3Cu-3Si alloys
(Elsevier, 2020)
To investigate the effect of grain refinement on the material properties of recently developed Al-25Zn-3Cu based alloys, Al-25Zn-3Cu, Al-25Zn-3Cu-0.01Ti, Al-25Zn-3Cu-3Si and Al-25Zn-3Cu-3Si-0.01Ti alloys were produced by ...
Performance analysis of a novel solar desalination system - Part 1: the unit with sensible energy storage and booster reflector without thermal insulation and cooling system
(Elsevier, 2020)
Solar desalination systems have a promising potential to meet the clean water demand at global scale in a cost-effective and eco-friendly manner. Therefore, in this research, a novel solar distillation unit with sensible ...
Effects of the center of linear heating position on natural convection and entropy generation in a linearly heated square cavity
(Pergamon-Elsevier Science Ltd, 2020)
Entropy generation and heat transfer caused by the natural convection in a square cavity, which is linearly heated from one of the vertical walls and uniformly cooled from the other vertical wall, is studied numerically. ...