Ara
Toplam kayıt 701, listelenen: 81-90
Understanding the mechanism of slope failure on a nearby highway tunnel route by different slope stability analysis methods: a case from NE Turkey
(Springer Heidelberg, 2016)
The Arakli tunnel is located in the eastern Black Sea region where the most mass movement is observed in Turkey. Following the tunnel entrance portal excavations in basaltic tuffs on nearby the Konakonu residential area, ...
A parametric study on exergetic sustainability aspects of high-pressure hydrogen gas compression
(Pergamon-Elsevier Science Ltd, 2016)
This paper presents a parametric study on exergetic sustainability aspects of high-pressure-hydrogen gas compression process in terms of exergy. in this regard, a single stage, two-stage, three-stage and four-stage-hydrogen ...
Numerical study on entropy generation in L-shaped curved channels
(Inderscience Enterprises Ltd, 2016)
A numerical study is performed on entropy generation in L-shaped curved channel for constant wall temperature boundary condition and fully developed laminar flow. An elliptic Fortran program based on SIMPLE algorithm is ...
Relationships between mechanical and tribological properties of Zn-15Al-based ternary and quaternary alloys
(Carl Hanser Verlag, 2016)
Five ternary Zn-15Al-(1- 5)Cu and six quaternary Zn15Al-3Cu-(0.5-3) Si alloys were prepared by permanent mold casting for this work. Their unlubricated sliding friction and wear properties were investigated at a pressure ...
Temperature-tuned band gap energy and oscillator parameters of GaS0.5Se0.5 single crystals
(Elsevier Gmbh, Urban & Fischer Verlag, 2016)
Temperature-dependent transmission and room temperature reflection measurements were carried out on GaS0.5Se0.5 single crystal in the wavelength range of 380-1000 nm to investigate its optical parameters. the analysis of ...
Investigation of the cutting forces and surface roughness in milling carbon fiber reinforced polymer composite material
(Inst Za Kovinske Materiale I in Tehnologie, 2016)
In this study, milling of a carbon-fiber-reinforced polymer composite material (CFRP) was investigated experimentally using various carbide end mills. the input parameters included the spindle speed, feed rate and cutting ...
Centri-voltammetric detection of epinephrine
(Royal Soc Chemistry, 2016)
The present study demonstrates a novel approach that has been proposed for epinephrine detection by using centri-voltammetry. the principle of the method is based on the accumulation of an analyte, here epinephrine, onto ...
Stability assessment of high-steep cut slope debris on a landslide (Gumushane, NE Turkey)
(Springer Heidelberg, 2016)
The objective of this study was to examine the effects on the stability of slope debris of planned slope excavations around the vicinity of Gumushane Imam-Hatip High School in NE Turkey. To assess the geotechnical properties ...
Effects of contact pressure and sliding speed on the unlubricated friction and wear properties of Zn-15Al-3Cu-1Si alloy
(Taylor & Francis Inc, 2016)
The unlubricated friction and wear properties of Zn-15Al-3Cu-1Si alloy were studied over a range of contact pressure (1-5 MPa) and sliding speed (0.5-2.5 ms(-1)) for a sliding distance of 2,500m using a block-on-disc type ...
Capacity building for field inspections: A comprehensive assessment tool for monitoring structural integrity and sediment capture performance of T-head groins
(Elsevier Sci Ltd, 2016)
Objectives of this study were to develop a field assessment tool (i.e., criteria and rubrics) which can be used during periodic inspections of T-head groins, specifically those constructed for controlling coastal erosion ...