Ara
Toplam kayıt 8, listelenen: 1-8
Investigation of the cutting forces and surface roughness in milling carbon fiber reinforced polymer composite material
(Inst Za Kovinske Materiale I in Tehnologie, 2016)
In this study, milling of a carbon-fiber-reinforced polymer composite material (CFRP) was investigated experimentally using various carbide end mills. the input parameters included the spindle speed, feed rate and cutting ...
Effects of contact pressure and sliding speed on the unlubricated friction and wear properties of Zn-15Al-3Cu-1Si alloy
(Taylor & Francis Inc, 2016)
The unlubricated friction and wear properties of Zn-15Al-3Cu-1Si alloy were studied over a range of contact pressure (1-5 MPa) and sliding speed (0.5-2.5 ms(-1)) for a sliding distance of 2,500m using a block-on-disc type ...
Experimental research on machinability characteristics of Al-9Si alloy: Effect of Sr and Mg additives
(Sage Publications, 2022)
In this study, the effects of strontium (Sr) and magnesium (Mg) elements in certain rates added to Al-9Si alloy manufactured using permanent mold casting technique on the structural, mechanical, and machinability properties ...
Experimental study on machinability of pre-hardened Toolox 44 and Nimax mould steels
(Gazi Üniversitesi Mühendislik Mimarlık Fakültesi, 2021)
In this study, the machinability of Nimax and Toolox 44 materials, which are among the mould steels was investigated experimentally. Cutting experiments were carried out with PVD-AlCrN coated carbide end mill using three ...
Kokil kalıba döküm yöntemi ile üretilmiş Al-12Si-(0,02-1)Sr alaşımlarının CVD-TiCN/Al2O3/TiN kaplamalı kesici uç ile tornada işlenmesinde kesme kuvveti ve yüzey pürüzlülüğü üzerine deneysel çalışma
(Gazi Üniversitesi , Fen Bilimleri Enstitüsü, 2022)
In this study, three Al-12Si-Sr alloys containing different ratios (0.02; 0.1 and 1%) strontium (Sr) were
manufactured by the permanent mold casting method. The microstructures of the manufactured alloys were
determined ...
Machinability properties of Al-7Si, Al-7Si-4Zn and Al-7Si-4Zn-3Cu alloys
(Springer Heidelberg, 2020)
Al-7Si, Al-7Si-4Zn, Al-7Si-4Zn-3Cu alloys were produced by permanent mold casting method to investigate the effects of copper and zinc additions on the machinability properties of Al-7Si alloy. the structural and mechanical ...
Performance evaluation of different carbide inserts in turning of newly developed Al-12Si-0.1Sr alloyLeistungsbewertung verschiedener Hartmetalleinsatze beim Drehen einer neu entwickelten Al-12Si-0.1Sr-Legierung
(Wiley, 2023)
An Al-12Si-0.1Sr alloy ingot was manufactured using a permanent mold casting technique. The microstructure and mechanical properties of this alloy were researched. Effects of different cutting conditions (cutting speed-V: ...
An experimental study on microstructural, mechanical and machinability properties of as-cast and heat-treated al-7Si-mg alloy
(Springer, 2024)
The automotive industry is constantly striving for targets for the development of lightweight materials for less fuel consumption and carbon emissions. For this purpose, lighter and higher-performance Al-Si alloys with ...