Ara
Toplam kayıt 211, listelenen: 11-20
Investigation of temperature distribution and performance of SOFC short stack with/without machined gas channels
(Pergamon-Elsevier Science Ltd, 2016)
Solid oxide fuel cells (SOFCs) generate clean energy via electrochemical reactions at high operating temperatures. the distribution of the electrochemical reactions in the cell depends on the flow field design of the ...
Exergoenvironmental and exergoeconomic analyses of a vertical type ground source heat pump integrated wall cooling system
(Pergamon-Elsevier Science Ltd, 2016)
In this study, exergoenvironmental, and exergoeconomic analyses of wall cooling systems fed by a vertical type of ground source heat pump integrated wall cooling system for cooling were examined experimentally and theoretically ...
A parametric study on exergetic sustainability aspects of high-pressure hydrogen gas compression
(Pergamon-Elsevier Science Ltd, 2016)
This paper presents a parametric study on exergetic sustainability aspects of high-pressure-hydrogen gas compression process in terms of exergy. in this regard, a single stage, two-stage, three-stage and four-stage-hydrogen ...
Numerical study on entropy generation in L-shaped curved channels
(Inderscience Enterprises Ltd, 2016)
A numerical study is performed on entropy generation in L-shaped curved channel for constant wall temperature boundary condition and fully developed laminar flow. An elliptic Fortran program based on SIMPLE algorithm is ...
Temperature-tuned band gap energy and oscillator parameters of GaS0.5Se0.5 single crystals
(Elsevier Gmbh, Urban & Fischer Verlag, 2016)
Temperature-dependent transmission and room temperature reflection measurements were carried out on GaS0.5Se0.5 single crystal in the wavelength range of 380-1000 nm to investigate its optical parameters. the analysis of ...
Investigation of the cutting forces and surface roughness in milling carbon fiber reinforced polymer composite material
(Inst Za Kovinske Materiale I in Tehnologie, 2016)
In this study, milling of a carbon-fiber-reinforced polymer composite material (CFRP) was investigated experimentally using various carbide end mills. the input parameters included the spindle speed, feed rate and cutting ...
Effects of contact pressure and sliding speed on the unlubricated friction and wear properties of Zn-15Al-3Cu-1Si alloy
(Taylor & Francis Inc, 2016)
The unlubricated friction and wear properties of Zn-15Al-3Cu-1Si alloy were studied over a range of contact pressure (1-5 MPa) and sliding speed (0.5-2.5 ms(-1)) for a sliding distance of 2,500m using a block-on-disc type ...
Temperature-dependent optical properties of GaSe layered single crystals
(Taylor & Francis Ltd, 2016)
Optical properties of GaSe single crystals have been investigated using temperature-dependent transmission and room temperature reflection measurements in the wavelength range of 380-1100nm. the analysis of the absorption ...
Exergy, exergoenvironmental and exergoeconomic evaluation of a heat pump-integrated wall heating system
(Pergamon-Elsevier Science Ltd, 2016)
In this study, a vertical ground source heat pump wall heating system belonging to the Yildiz Renewable Energy House on the Davutpasa Campus of Yildiz Technical University was experimentally and theoretically studied. the ...
Exergetic sustainability improvement potentials of a hydrogen fuelled turbofan engine UAV by heating its fuel with exhaust gasses
(Pergamon-Elsevier Science Ltd, 2016)
Exergetic sustainability parameters such as, exergy efficiency, waste exergy ratio, environmental effect factor and exergetic sustainability index were investigated for an UAV having a turbofan engine for the case its ...