Ara
Toplam kayıt 32, listelenen: 11-20
Capacity building for field inspections: A comprehensive assessment tool for monitoring structural integrity and sediment capture performance of T-head groins
(Elsevier Sci Ltd, 2016)
Objectives of this study were to develop a field assessment tool (i.e., criteria and rubrics) which can be used during periodic inspections of T-head groins, specifically those constructed for controlling coastal erosion ...
Utilizing the strength conversion factor in the estimation of uniaxial compressive strength from the point load index
(Springer Heidelberg, 2016)
The strength conversion factor (k) is the ratio between the uniaxial compressive strength (UCS) and the point load index (PLI). It has been used to estimate the UCS from the PLI since the 1960s. Many researchers have ...
A receding contact problem between a functionally graded layer and two homogeneous quarter planes
(Springer Wien, 2016)
In this paper, the plane problem of a frictionless receding contact between an elastic functionally graded layer and two homogeneous quarter planes is considered when the graded layer is pressed against the quarter planes. ...
The investigation crack problem through numerical analysis
(Techno-Press, 2016)
This paper presents a comparative study of finite element method (FEM) and analytical method for the plane problem of a layered composite containing an internal perpendicular crack in literature. the layered composite ...
Stability analyses of submicron-boron mineral prepared by mechanical milling process in concrete roads
(Elsevier Sci Ltd, 2016)
The main objective of this study is to investigate the possibility of utilizing nano/submicron sized boron mineral (colemanite) in Portland cement concrete. Colemanite was obtained from a mine in three different sizes as ...
Transition coefficients between compressive strengths of samples with different shape and size in mass concrete and use of weight maturity method in dam construction
(Ernst & Sohn, 2019)
Mass concrete (MC) is widely used in dam concretes due to their large aggregate grain diameters, low cement dosage, and low hydration temperatures. Monitoring of the hydration temperature and compressive strength is an ...
Effect of PCA on nanosized ulexite material prepared by mechanical milling
(Springer Heidelberg, 2017)
Raw ulexite (U-3 mm) mineral used as a initial material was milled by using mechanical milling method, the milling time of which is from 0 to 8 h. Particle size, morphology, elemental and crystal structure measurements of ...
Geotechnical assessment of a slope stability problem in the Citlakkale residential area (Giresun, NE Turkey)
(Springer Heidelberg, 2017)
Because of the rapidly growing population, new settlement areas are required, and finding an appropriate location is always difficult, especially in mountainous areas. in these regions, efficient use of the existing ...
Geotechnical investigations and remediation design for failure of tunnel portal section: a case study in northern Turkey
(Science Press, 2017)
Mass movements are very common problems in the eastern Black Sea region of Turkey due to its climate conditions, geological, and geomorphological characteristics. High slope angle, weathering, dense rainfalls, and anthropogenic ...
Environmental effects of t-shaped groins built on the eastern black sea coast on shore protection
(Parlar Scientific Publications (P S P), 2017)
The construction of the double highway on the Black Sea Coast was initiated in 1998, completed in 2000. During the construction, T-shaped groins where were built to protect the shore. in this article, the contribution of ...